When you buy warman slurry pump parts, please pay more attention to weight, not the low price suppliers offer When you buy warman slurry pump parts, please pay more attention to weight, not the low price suppliers offer
1. slurry pump weight
Why the slurry pump weight first ? Because the weight is the most simple, and also the most commonly used method. Slurry pump casting cost is based on the weight calculation,for example,a slurry pump impeller is 50 kg according to drawing requirements,but if the manufacturer reduce the weight of impeller to 35 kg, assuming that the price of per kg is 5 USD,it would save 75 USD.
Here are some standard high chrome alloy weight of warman A05 slurry pump impeller/volute/throatbush/FPL insert:
Slurry pump impeller : B1127NA:4Kg, B15127NA:6.3Kg, C2147:17Kg , D3147NA:24Kg, E4147:69Kg, F6147:190Kg, G8147:373Kg, G10147:490Kg, GAM14147:1123Kg.
Slurry pump volute liner: B1110NA:11.5Kg, B15110NA:14.1Kg, C2110NA:36Kg, D3110:66.5Kg, E4110:120Kg, F6110: 282Kg, G8110:375.5Kg, G10110:611Kg, G12110:1100Kg, H14110:1403Kg.
Slurry pump throatbush: E4083:48.4Kg, F6083:117.5Kg, G8083:188Kg, G10083:250Kg, G12083:390Kg, H14083:496Kg.
Slurry pump frame plate liner insert: B1041NA:3.5Kg, B15041NA:4.3Kg, C2041:7Kg, D3041:17Kg, E4041:31.6Kg, F6041:84Kg, G8041:164Kg, G10041:221.5Kg, G12041:370Kg, H14041:400Kg.
2. slurry pump raw material and hardness
The raw material of the slurry pump includes chromium (Cr), copper, manganese, nickel, silicon, iron, molybdenum, etc.
For example:hight chrome alloy A05(KmTBCr26),chrome alloy content should not less than 26%,nickel content should be 5%
,but in reality the chrome may be less than 20%,or there is no nickel at all.And the slurry pump hardness should be adjusted
between 56HRC to 60HRC to get good characteristics for toughness and wear resistance. Do you think that it doesn`t matter?
So when your Chinese slurry pump supplier gives you a very very low price, please keep an eye on the quality.
2016 08/18